Tag: ideality factor

The diode ideality factor in organic solar cells: basics

Where does one start after so long an absence — meaning only the blog abstinence; I have been working and publishing since last time;-) Passing by One of the things which have been on my mind is the ideality factor, a figure of merit for the charge carrier recombination mechanism in a semiconductor diode. In short, a diode ideality factor of 1 is interpreted as direct recombination of electrons and holes across the bandgap. An ideality factor of 2 is interpreted as recombination through defects states, i.e. recombination centres. More on that in a later post, let’s start with the basics.

A couple of years ago, I wrote about some general properties of current-voltage characteristics of organic solar cells, but did not describe the ideality factor.1 I think the ideality factor was mentioned only once, and then without details.

The Shockley diode equation describes the current–voltage characteristics of a diode,

j=j_0 \left(\exp\left(\frac{eV}{n_{id}kT}\right)-1\right) - j_{gen}.

Here, j current, V the voltage, e elementary charge, kT thermal voltage, j_0 the dark saturation current, and j_{gen} the photogenerated current. If the ideality factor n_{id} was equal to one, one could call this the ideal Shockley equation. It derivation can be found in semiconductor text books, but it can also be derived based on thermodynamic arguments (see Peter Würfel’s excellent book on the physics of solar cells).

The current j flowing out of the diode is defined to be negative. Essentially, the charge carriers which can flow out are the generated ones (e.g. j_{gen}), but reduced by the recombination current. That means,

j=\underbrace{j_0 \left(\exp\left(\frac{eV}{n_{id}kT}\right)-1\right)}_{j_{rec}} - j_{gen}.

However, the term j_{rec} contains also a negative contribution, j_0 times the -1 from the bracket. This is the thermal generation current j_{gen,th} \equiv j_0, i.e. charge carriers excited across the bandgap just by thermal energy — and therefore very little. Still, the term is very important, as it is the prefactor of the whole j(V) curve. Without light, i.e. with photocurrent j_{gen}=0, we can clarify

j=\underbrace{j_0 \exp\left(\frac{eV}{n_{id}kT}\right)}_{j_{rec,dark}} - \underbrace{j_0}_{j_{gen,th}}.

so that at negative voltages, j=-j_0.Jdark (Please note that under realistic conditions, j_0 is not only pretty small and difficult to measure in principle, it is also hidden behind shunt currents in the device. ) At zero volt, j=j_0-j_0=0. Thus, generation = recombination — or more specifically, thermal generation current = recombination current — which essentially implies that 0V correspond to the open circuit voltage in the dark.

How can one determine the ideality factor and the dark saturation current (at least in principle, see below for a better way on real devices)? It is common to neglect the thermal generation current (the term -1, multiplied by j_0), which is a good approximation for voltages some kT/e larger than 0. Then, calculate the logarithm of the dark current (j_{gen}=0),

\ln(j) = \ln(j_0) +\frac{e}{n_{id}kT}V,

so that the ideality factor can be determined from the inverse slope of the ln(current) at forward bias, and the dark saturation current from the current-axis offset. Let me already tell you that I do not recommend this approach, for reasons written below, and as explained in more detail in a recent paper of Kris Tvingstedt and myself [Tvingstedt/Deibel 2016].

Under illumination and at open circuit conditions, j(V_{oc})=0, we can rewrite the Shockley equation as

j_{gen}=j_0 \left(\exp\left(\frac{eV_{oc}}{n_{id}kT}\right)-1\right),

which has the same shape as the Shockley equation in the dark. This means that if you measure (j_{gen}, V_{oc}) pairs for a (wide) range of different illumination intensities (thus varying j_{gen}), the points should overlap with the dark j(V) curve! We’ll come back to this important point further below. Note that for solar cells with good fill factor, j_{gen} can be approximated by the short circuit current j_{sc}. Continue reading “The diode ideality factor in organic solar cells: basics”

Advertisement